ATIS Telecom Glossary
Tuesday, July 29, 2014

A B C D E F G H I
J K L M N O P Q R
S T U V W X Y Z  
Go
 
Glossary Home
Foreword
Introduction
Normative References
Using the ATIS Telecom Glossary
Annex A: Informative References
 
 
 
<< Back
design objective (DO)
In communications systems, a desired performance characteristic for communications circuits and equipment that is based on engineering analyses, but (a) is not considered feasible to mandate in a standard, or (b) has not been tested. Note 1: DOs are used because applicable systems standards are not in existence. Note 2: Examples of reasons for designating a performance characteristic as a DO rather than as a standard are (a) it may be bordering on an advancement in the state of the art, (b) the requirement may not have been fully confirmed by measurement or experience with operating circuits, and (c) it may not have been demonstrated that the requirement can be met considering other constraints, such as cost and size. Note 3: A DO is sometimes established in a standard for developmental consideration. A DO may also specify a performance characteristic that may be used in the preparation of specifications for development or procurement of new equipment or systems.

 

 

 

 

 

 

 

 

 

 



 
These definitions were prepared by ATIS Committee PRQC
 
For more information on the work related to these definitions,
please visit the ATIS website and the ATIS Document Center