ATIS Telecom Glossary
Sunday, April 20, 2014

A B C D E F G H I
J K L M N O P Q R
S T U V W X Y Z  
Go
 
Glossary Home
Foreword
Introduction
Normative References
Using the ATIS Telecom Glossary
Annex A: Informative References
 
 
 
<< Back
cutback technique
A destructive technique for determining certain optical fiber transmission characteristics, such as attenuation and bandwidth, by (a) performing the desired measurements on a long length of the fiber under test, (b) cutting the fiber under test at a point near the launching end, (c) repeating the measurements on the short length of fiber, and (d) subtracting the results obtained on the short length to determine the results for the residual long length. Note 1: The cut should not be made less than 1 meter from the launch end. However, cutting the fiber so close to the launch end (in a multimode fiber) will introduce errors in the measurements because at that point, modal equilibrium conditions have not been established. The errors so introduced will result in conservative results (i.e., higher transmission losses and lower bandwidths) than would be realized under equilibrium conditions. Note 2: Several characteristics may be determined using the same test fiber. Note 3: A variation of the cutback technique is the substitution method, in which measurements are made on a full length of fiber, and then on a short length of fiber having the same characteristics (core size, numerical aperture), with the results from the short length being subtracted to give the results for the full length.

 

 

 

 

 

 

 

 

 

 



 
These definitions were prepared by ATIS Committee PRQC
 
For more information on the work related to these definitions,
please visit the ATIS website and the ATIS Document Center